Fig. 4: Identifying Cowl Grille, Windshield Washer Hose And Joint Pipe
Courtesy of MAZDA MOTORS CORP.
FRONT BELTLINE MOLDING REMOVAL/INSTALLATION
REMOVAL
1. Fully open the front door glass.
2. Disconnect the negative battery cable.
3. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
4. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
5. Remove the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION .)
6. Remove clip A using a protective tape-wrapped flathead screwdriver.
7. Lift (partially peeling back) the front beltline molding in the direction of the arrow and then remove tabs
B.
8. Remove the clip C.
9. Remove the front beltline molding.
Fig. 5: Identifying Front Beltline Molding With Clips And Tab
Courtesy of MAZDA MOTORS CORP.
INSTALLATION
1. Install the clip A.
2. Install the tabs B.
3. Install the clip C.
4. Install the front beltline molding.
5. Install the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Exterior Trim - Mazda CX-9