Mazda CX-9 Grand Touring 2009 Manual page 1137

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Verify that all disconnected
connectors reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM memory
using the M-MDS.
6
Perform the "KOEO and KOER self-
test". (See KOEO/KOER SELF
TEST [MZI-3.7].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this DTC
present?
VERIFY AFTER REPAIR
PROCEDURE
Perform the "AFTER REPAIR
7
PROCEDURE". (See AFTER
REPAIR PROCEDURE [MZI-3.7].)
Are any DTC present?
DTC P0610 [MZI-3.7]
DTC P0610 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P0610
DETECTION CONDITION
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P0610 (MZI-3.7) DIAGNOSTIC PROCEDURE
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
2
Verify related Service Bulletins
2008 Mazda CX-9 Grand Touring
Replace the PCM, then go to the next step. (See
Yes PCM REMOVAL/INSTALLATION [MZI-
3.7] .)
No
Go to the applicable DTC inspection. (See DTC
Yes
TABLE [MZI-3.7].)
No
Control module vehicle options error
Indicates a PCM vehicle options error.
Module reprogramming
Aftermarket performance products.
PCM malfunction.
Yes Go to the next step.
Record FREEZE FRAME DATA on the repair
No
Perform repair or diagnosis according to the
available Service Bulletins.
Yes
Go to the next step.
Troubleshooting completed.
ACTION
order, then go to the next step.
If the vehicle is not repaired, go to the next