2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Is the PENDING CODE for this DTC
present?
VERIFY TROUBLESHOOTING OF
DTC P2101 HAS BEEN COMPLETED
Verify that all disconnected
connectors reconnected.
Start the engine.
6
Clear DTC from PCM memory using
M-MDS.
Perform the "KOEO/KOER Self-
Test". (See KOEO/KOER SELF
TEST [MZI-3.7].)
Is same DTC present?
VERIFY AFTER REPAIR
PROCEDURE
Perform the "AFTER REPAIR
7
PROCEDURE". (See AFTER
REPAIR PROCEDURE [MZI-3.7].)
Are any DTCs present?
DTC P2104, P2105, P2106, P2110 [MZI-3.7]
DTC P2104, P2105, P2106, P2110 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P2104
P2104: Throttle actuator control system - forced idle
DTC P2105
P2105: Throttle actuator control system - forced engine shutdown
DTC P2110
P2110: Throttle actuator control system - forced limited RPM
DETECTION
CONDITION
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P2104, P2105, P2106, P2110 (MZI-3.7) DIAGNOSTIC PROCEDURE
STEP
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
recorded?
2008 Mazda CX-9 Grand Touring
The TAC system is in the failure mode effects management (FMEM) mode.
This DTC is an informational DTC and may be set in combination with a
number of other DTCs which are causing the FMEM. Diagnose other DTCs
first.
INSPECTION
Replace the PCM, then go to the next step. (See
Yes
PCM REMOVAL/INSTALLATION [MZI-
3.7] .)
No
Go to the next step.
Go to the applicable DTC inspection. (See DTC
Yes
TABLE [MZI-3.7].)
No
Troubleshooting completed.
Yes Go to the next step.
Record FREEZE FRAME DATA on the
No
repair order, then go to the next step.
ACTION