Mazda CX-9 Grand Touring 2009 Manual page 1459

NOTE:
Lubricate the contact surface (exterior area of inner diameter) of the front
oil seal with clean engine oil.
1. Install the crankshaft pulley, washer, and SST to the crankshaft.
Fig. 73: View Of Crankshaft Pulley & Washer
Courtesy of MAZDA MOTORS CORP.
2. Tighten the SST nut and install the crankshaft pulley.
Fig. 74: Installing Crankshaft Pulley With SST
Courtesy of MAZDA MOTORS CORP.
CRANKSHAFT PULLEY LOCK BOLT INSTALLATION NOTE
1. Set a flathead screwdriver to the drive plate in the position indicated in the figure to lock the crankshaft
rotation.
2. Tighten the new crankshaft pulley lock bolt in four steps.
1. Tighten to 140 N.m {14 kgf.m, 103 ft.lbf}.
2. Loosen 360 ° (one full turn) in reverse order.
3. Tighten to 47-53 N.m {4.8-5.4 kgf.m, 35-39 ft.lbf}.
4. Tighten 85 °--95 °.
3. Install the starter. (See STARTER REMOVAL/INSTALLATION [MZI-3.7] .)
2008 Mazda CX-9 Grand Touring
2008 ENGINE Mechanical (MZI-3.7) - Mazda CX-9