Mazda CX-9 Grand Touring 2009 Manual page 1877

REMOVAL/INSTALLATION.)
2. Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
3. Console panel (LH) (See CONSOLE PANEL REMOVAL/INSTALLATION.)
4. Hood release lever (See HOOD LATCH AND RELEASE LEVER
REMOVAL/INSTALLATION .)
3. Remove the screw.
4. Detach clips A and hook B by pulling them in the direction of the arrow.
5. Remove the hook B.
6. Disconnect the head light leveling switch connector and TCS OFF switch connector.
7. Disconnect the BSM OFF switch connector. (Vehicles with BSM)
8. Disconnect the PLG switch connector. (Vehicles with PLG)
9. Disconnect the cabin temperature sensor connector and air hose.
10. Remove the lower panel.
11. Install in the reverse order of removal.
Fig. 15: Identifying Lower Panel Components
Courtesy of MAZDA MOTORS CORP.
SIDE PANEL REMOVAL/INSTALLATION
1. Remove the glove compartment service hole cover. (See AIR FILTER
REMOVAL/INSTALLATION .)
2. Insert fingers into the glove compartment service hole and detach the tabs A.
3. Remove the side panel in the direction of the arrow.
4. Install in the reverse order of removal.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Interior Trim - Mazda CX-9