Mazda CX-9 Grand Touring 2009 Manual page 1173

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
verify that they seat correctly.
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this DTC
present?
VERIFY TROUBLESHOOTING OF DTC
P0690 HAS BEEN COMPLETED
Verify that all disconnected connectors
reconnected.
Clear the DTC from the PCM memory
using the M-MDS.
6
Clear the DTC from the PCM memory
using the M-MDS.
Perform the "KOEO or KOER self-test"
using the M-MDS. (See KOEO/KOER
SELF TEST [MZI-3.7].)
Is the PENDING CODE for the DTC
present?
VERIFY AFTER REPAIR PROCEDURE
Perform the "AFTER REPAIR
7
PROCEDURE". (See AFTER REPAIR
PROCEDURE [MZI-3.7].)
Are any DTCs present?
DTC P1000 [MZI-3.7]
DTC P1000 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P1000
DETECTION
CONDITION
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P1000 (MZI-3.7) DIAGNOSTIC PROCEDURE
2008 Mazda CX-9 Grand Touring
OBD-II systems readiness test not complete
P1000 indicates that the OBD-II monitor testing is not complete.
The vehicle is new from the factory and has not yet completed an OBD-
II Drive Cycle.
The battery or the PCM has been disconnected.
OBD-II monitor malfunction had occurred before completion of an
OBD-II Drive Cycle.
The PCM DTCs have been cleared with an M-MDS tester as part of a
service process.
No The system is correctly. Go to the next step.
Replace the PCM, then go to the next step.
Yes (See PCM REMOVAL/INSTALLATION
[MZI-3.7] .)
No Go to the next step.
Go to the applicable DTC inspection. (See
Yes
DTC TABLE [MZI-3.7].)
No Troubleshooting completed.