Mazda CX-9 Grand Touring 2009 Manual page 1140

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
test". (See KOEO/KOER SELF
TEST [MZI-3.7].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this DTC
present?
VERIFY AFTER REPAIR
PROCEDURE
Perform the "AFTER REPAIR
6
PROCEDURE". (See AFTER
REPAIR PROCEDURE [MZI-3.7].)
Are any DTCs present?
DTC P061F [MZI-3.7]
DTC P061F (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P061F Internal control module throttle actuator controller performance
DETECTION
CONDITION
NOTE:
POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC P061F (MZI-3.7) DIAGNOSTIC PROCEDURE
STEP
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins and/or
2
on-line repair information availability.
Is any related Service Bulletins
available?
VERIFY RELATED PENDING CODE
OR STORED DTCs
Turn the ignition switch off then to the
2008 Mazda CX-9 Grand Touring
Indicates that a calculation error occurred in the PCM.
This DTC is an informational DTC and may be set in combination with a
number of other DTCs which are causing the FMEM. Diagnose other
DTCs first.
INSPECTION
No Go to the next step.
Go to the applicable DTC inspection. (See DTC
Yes
TABLE [MZI-3.7].)
No Troubleshooting completed.
ACTION
Yes Go to the next step.
Record FREEZE FRAME DATA on the repair
No
order, then go to the next step.
Perform repair or diagnosis according to the
available Service Bulletins.
Yes
If the vehicle is not repaired, go to the
next step.
No Go to the next step.
Go to the appropriate DTC troubleshooting. (See
Yes
DTC TABLE [MZI-3.7].)