Mazda CX-9 Grand Touring 2009 Manual page 1174

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
STEP
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins and/or
2
on-line repair information availability.
Is any related Service Bulletins
available?
DTC P1000: INSPECT FOR OTHER DTCS
This test should be used only if DTC
P1000 was received in Continuous
Memory. Ignore any DTC P1000s in
KOEO or KOER.
3
NOTE:
DTC P1000 indicates that all of
the OBD-II monitors have not
yet been successfully tested to
clear DTC P1000.
Were any other DTCs received with
P1000?
REQUEST TO CLEAR DTC P1000
4
Has the customer requested DTC P1000
be cleared from the PCM memory?
VERIFY AFTER REPAIR PROCEDURE
Perform the "AFTER REPAIR
5
PROCEDURE". (See AFTER
REPAIR PROCEDURE [MZI-3.7].)
Are any DTC present?
DTC P1001 [MZI-3.7]
DTC P1001 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
2008 Mazda CX-9 Grand Touring
INSPECTION ACTION
Yes Go to the next step.
Record FREEZE FRAME DATA on the repair
No
order, then go to the next step.
Perform repair or diagnosis according to the
available Service Bulletins.
Yes
If the vehicle is not repaired, go to the
next step.
No Go to the next step.
Repair other DTCs. Go to the applicable DTC
Yes
Troubleshooting.
No Go to the next step.
Perform the Drive Mode.
Yes
(See OBD-II DRIVE MODE [MZI-3.7].)
Inform customer that if the law in the state
requires additional driving in order to clear
No DTC P1000 from the PCM memory, it must be
performed before an inspection maintenance
Go to the applicable DTC inspection. (See
Yes
DTC TABLE [MZI-3.7].)
No Troubleshooting completed.
test.