Mazda CX-9 Grand Touring 2009 Manual page 1789

REAR HEAT DUCT NO.2, NO.3 AND NO.4
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
2. Front console box mat (See FRONT CONSOLE BOX MAT REMOVAL/INSTALLATION .)
3. Indicator panel (See INDICATOR PANEL REMOVAL/INSTALLATION .)
4. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
5. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
6. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
7. Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION .)
8. Console cover (See CONSOLE COVER REMOVAL/INSTALLATION .)
9. Console (See CONSOLE REMOVAL/INSTALLATION .)
10. Second-row seat (See SECOND-ROW SEAT REMOVAL/INSTALLATION .)
11. Edge cover (See LONG SLIDER REMOVAL/INSTALLATION .)
12. Long slider cover (See LONG SLIDER REMOVAL/INSTALLATION .)
13. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
14. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
15. Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
16. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
17. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
18. Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
19. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
20. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
3. Remove the two rear A/C unit retaining bolts on the rear side.
4. Turn floor covering over. (See FLOOR COVERING REMOVAL/INSTALLATION .)
5. Remove the long slider. (See LONG SLIDER REMOVAL/INSTALLATION .)
6. Remove the fasteners.
7. Lift the rear side of the rear A/C unit and remove the rear heater duct No.2.
8. Remove the rear heat duct No.3.
9. Remove the rear heat duct No.4.
10. Install in the reverse order of removal.
2008 Mazda CX-9 Grand Touring
2008 HVAC Basic System - Mazda CX-9