Transmission Automatic Transaxle Overhaul (Aw6A-El) - Cx-7, Cx-9 & Mazda - Mazda CX-9 Grand Touring 2009 Manual

2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6 2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
AUTOMATIC TRANSAXLE
AUTOMATIC TRANSAXLE DISASSEMBLY
Precaution
The following are precautions that must be followed when performing removal/installation.
1. Handle electronic parts with care
Do not pull the wiring harness forcibly when disconnecting the connector. Unlock the lock first and
pull the connector.
When connecting the connector, verify to insert it until it is properly locked. (Verify that a click
sound is heard.)
Do not shock electronic parts. Replace with new parts if they have been dropped or subjected to
shock.
2. Prevent foreign matter from penetrating
Be sure to remove foreign matter such as dust and sand from the automatic transaxle before
removing parts.
Protect removed parts from dust with an object such as a vinyl sheet.
Do not use cotton work gloves or shop rags as frayed strings might get caught in the unit. Thus
work with bare hands or use vinyl gloves.
3. Prevent scratching
Do not pry with a screwdriver forcibly. Slightly hit the case with a plastic hammer when separating
component cases at seams.
Do not pull the valve forcibly.
Be careful not to get the wire harness caught between parts during installation.
4. Prevent incorrect installation and lack of or missing parts
Be careful not to install parts incorrectly or lose parts since there are similar types of O-rings, snap
rings, bearings and races. Take great care for straightening parts and checking installation direction.
Be careful not to drop small parts such as check balls or lose them during installation.
5. Wash parts and apply oil
Wash each part before installing and dry using compressed air, and then apply the specified ATF
type JWS3309.
Soak disks in ATF type JWS3309 before installing. In particular, soak new disks for 2 h or more
so that the oil seeps into the lining.
If the thrust bearing or race falls during installation, use a small amount of yellow petrolatum
grease.
Apply ATF type JWS3309 to contact and rotating surfaces.
2008 Mazda CX-9 Grand Touring 2008 Mazda CX-9 Grand Touring
2005-08 TRANSMISSION