Mazda CX-9 Grand Touring 2009 Manual page 1840

2008 BODY & ACCESSORIES Instrumentation/Driver Info - Mazda CX-9
BLIND SPOT MONITORING (BSM) CONTROL MODULE
REMOVAL/INSTALLATION
CAUTION:
1. Disconnect the negative battery cable.
2. Remove the rear combination light. (See REAR COMBINATION LIGHT
REMOVAL/INSTALLATION .)
3. Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION .)
4. Pull the connector in the direction shown by the arrow (2) in the+ figure and remove it while pressing the
tab in the direction shown by arrow (1).
5. Remove the nuts.
6. Remove the BSM control module.
7. Install in the reverse order of removal.
8. Perform the blind spot monitoring radar test. (See BLIND SPOT MONITORING (BSM) RADAR
TEST.)
Fig. 16: View Of Blind Spot Monitoring Control Module & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
BLIND SPOT MONITORING (BSM) CONTROL MODULE INSPECTION
1. Remove the trunk box. (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Remove the seat side box. (BSM control module (LH) only) (See SEAT SIDE BOX
REMOVAL/INSTALLATION .)
3. Remove the trunk end trim. (BSM control module (LH) only) (Vehicles with Bose®) (See TRUNK END
2008 Mazda CX-9 Grand Touring
All segments and dots illuminated. LCD is normal.
Except above
If the BSM control modules are installed with the left and right
modules reversed, a DTC will be displayed and system will enter the
fail-safe function. Therefore, confirm that the left/right BSM control
modules are installed correctly.
Replace the information display.