Mazda CX-9 Grand Touring 2009 Manual page 1132

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
DIAGNOSTIC PROCEDURE
DTC P0606 (MZI-3.7) DIAGNOSTIC PROCEDURE
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins
2
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
VERIFY TROUBLESHOOTING OF
P0606 HAS BEEN COMPLETED
Verify that all disconnected
connectors are reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM
3
memory using the M-MDS.
Perform the "KOEO and KOER self-
test". (See KOEO/KOER SELF
TEST [MZI-3.7].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this DTC
present?
VERIFY AFTER REPAIR
PROCEDURE
Perform the "After Repair Procedure".
4
(See AFTER REPAIR
PROCEDURE [MZI-3.7].)
Are any DTCs present?
DTC P0607 [MZI-3.7]
DTC P0607 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P0607 Control module performance
2008 Mazda CX-9 Grand Touring
Yes Go to the next step.
Record FREEZE FRAME DATA on the repair
No
Perform repair or diagnosis according to the
available Service Bulletins.
Yes
Perform PCM reprograming using the M-MDS,
No
Replace the PCM, go to the next step. (See PCM
Yes
REMOVAL/INSTALLATION [MZI-3.7] .)
No
Go to the applicable DTC inspection. (See DTC
Yes
TABLE [MZI-3.7].)
No
ACTION
order, then go to the next step.
If the vehicle is not repaired, go to the next
step.
then go to next step.
Go to the next step.
Troubleshooting completed.