2. Remove the front wheel and tire (RH). (See GENERAL PROCEDURES (SUSPENSION) .)
3. Remove the splash shield (RH).
4. Remove the generator and A/C drive belt. (See DRIVE BELT REMOVAL/INSTALLATION [MZI-
3.7].)
5. Verify that the drive belt auto tensioner moves smoothly in the operational direction.
Replace the drive belt auto tensioner if necessary.
Tightening torque: 8.9-12.1 N.m {91-123 kgf.cm, 79-107 in.lbf}
6. Turn the drive belt auto tensioner pulley by hand and verify that it rotates smoothly.
Replace the drive belt auto tensioner if necessary.
Tightening torque: 8.9-12.1 N.m {91-123 kgf.cm, 79-107 in.lbf}
Fig. 10: Turning Drive Belt Auto Tensioner Pulley
Courtesy of MAZDA MOTORS CORP.
7. Install in the reverse order of removal.
Fig. 11: Identifying Drive Belt Auto Tensioner Pulley
Courtesy of MAZDA MOTORS CORP.
ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7]
2008 Mazda CX-9 Grand Touring
2008 ENGINE Mechanical (MZI-3.7) - Mazda CX-9