Mazda CX-9 Grand Touring 2009 Manual page 1697

10. Selector lever component (See SELECTOR LEVER COMPONENT
REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Fig. 29: Identifying Rear Blower Motor Removal Order
Courtesy of MAZDA MOTORS CORP.
REAR BLOWER MOTOR INSPECTION
1. Connect battery positive voltage to rear blower motor terminal B, connect terminal A to ground, and then
verify its operation.
If there is any malfunction, replace the rear blower motor.
Fig. 30: Inspecting Rear Blower Motor
Courtesy of MAZDA MOTORS CORP.
FRONT POWER METAL OXIDE SEMICONDUCTOR FIELD EFFECT
TRANSISTOR (POWER MOS FET) REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the dashboard under cover, (passenger side) (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION .)
3. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
4. Insert a flathead screwdriver as shown in the figure and detach the fuse block tab by prying it in the
direction of the arrow.
2008 Mazda CX-9 Grand Touring
2008 HVAC Control System (HVAC) - Mazda CX-9