2008 BODY & ACCESSORIES Instrumentation/Driver Info - Mazda CX-9
Courtesy of MAZDA MOTORS CORP.
10. Install the SSTs (reflector and plum-bob) to the SST (tripod) and adjust the height of the reflector at its
center to 534 mm ± 8 mm {21.0 in ± 0.3 in}.
Fig. 31: Identifying Height Of Reflector
Courtesy of MAZDA MOTORS CORP.
11. Verify visually that the reflecting surface of the reflector is facing the BSM control module, and position
the SST (tripod) so that the SST (plum-bob) is positioned over the marked position.
Fig. 32: Identifying Center Plumbob Over Floor Mark
Courtesy of MAZDA MOTORS CORP.
NOTE:
12. Perform the BSM radar test according to the screen instructions using the IDS.
NOTE:
2008 Mazda CX-9 Grand Touring
The BSM installation position is indicated in the figure.
Use the IDS (laptop PC) because the PDS (Pocket PC) does not
support the blind spot monitoring (BSM) radar test.