Mazda CX-9 Grand Touring 2009 Manual page 1954

3. Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "LCM".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
If a DTC (s) is detected, perform the applicable DTC inspection. (See DTC TABLE [AUTO
LIGHT/WIPER CONTROL MODULE] .)
Fig. 56: Identifying DLC-2 Location
Courtesy of MAZDA MOTORS CORP.
AUTO LIGHT ILLUMINATION LEVEL SETTING
WITHOUT USING M-MDS
CAUTION:
NOTE:
Perform the procedure in a condition that allows verification of the
headlight illumination because it is necessary to verify the setting
condition according to the number of times headlights turn on.
1. Turn the ignition switch to the ON position with the light switch in the OFF position and pulled back
(Flash-to-pass ON).
2. Switch the light switch from the OFF to TNS position five times and return it to the OFF position.
3. Pull the light switch back once. (Flash-to-pass ON)
4. Turn the light switch to the TNS position.
5. Switch the light switch from the TNS to ON position five times and return it to the TNS position.
6. Turn the light switch to the ON position.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Lighting Systems - Mazda CX-9
If any of the following occurs, the sensitivity cannot be set properly.
Therefore, resume from Step 1.
Each procedure and operation interval exceeds 5 s.
Procedures are performed incorrectly.