Mitsubishi MELSEC Q Series Programming Manual page 824

PSWAPP
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and
an error code is stored into SD0.
• The drive No. or the file name designated by
• The drive No. designated by
• There is not enough memory to load the specified program in drive 0.
• The program designated by
Program Example
(1) The following program deletes "EFGH.QPG" stored in drive 0 from the memory, transfers
"ABCD.QPG" stored in drive 4 to drive 0, and places the program in standby status when M0
is turned from OFF to ON.
[Ladder Mode]
7-450
or
S1 S2
is invalid.
S1
is not in standby status or is being executed.
S1
[List Mode]
Step
does not exist.
(Error code: 2410)
(Error code: 4100)
(Error code: 2413)
(Error code: 4101)
Instruction Device