Tan Operation On Floating-Point Data (Single Precision) (Tan(P)) - Mitsubishi MELSEC Q Series Programming Manual

7.12.5
TAN operation on floating-point data (Single precision)
(TAN(P))
TAN(P)
TAN
TANP
Setting
Data
S
D
Function
(1) Returns the tangent (TAN) value of the angle data designated by
result in device designated by
(2) Angles designated at
For conversion between degrees and radian values, see the RAD and DEG instructions.
(3) When angles designated by
be generated in the calculation of the radian value, so care must be taken to avoid such
errors.
Basic model QCPU: The upper five digits of the serial No. are "04122" or larger.
Command
Command
: Angle data of which the TAN (tangent) value is obtained or head number of the devices where the angle data
S
is stored (real number)
: Head number of the devices where the operation result will be stored (real number)
D
Internal Devices
R, ZR
Bit Word
––
––
.
D
S +1 S
TAN (
32-bit floating-point
real number
are set in radian units (degrees
S
are
S
Ver.
High
Basic
performance
TAN
TANP
J \
U \G
Bit Word
––
––
*1: Applicable for the Universal model QCPU, LCPU.
D +1 D
)
32-bit floating-point
real number
/2 radians, or (3/2) radians, an operation error will
TAN(P)
Process
Redundant Universal LCPU
S D
S D
Constants
Zn Other
E
*1
––
*1 –– ––
, and stores operation
S
/ 180).
7-257
1
2
3
4
6
6
7
8