Registering Routing Information (S(P).Rtwrite) - Mitsubishi MELSEC Q Series Programming Manual

RTWRITE
8.2.2

Registering routing information (S(P).RTWRITE)

RTWRITE
S.RTWRITE
SP.RTWRITE
Setting
Data
n
S
Function
(1) Registers routing data of
specified by n in the routing parameters.
(2) The following shows the contents of data to be set at
(3) If data for the transfer destination network number specified by n is set in the routing
parameters, it is used to update the data in the area starting from
(4) If all data in
number specified by n is deleted from the routing parameters.
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and
an error code is stored into SD0.
• When data specified by n is other than 1 to 239.
• When the data of
• When the total number of routing information registered in the routing parameter of the
network parameters and routing information registered with the RTWRITE instruction
exceeds 64.
• The device specified by
(For the Universal model QCPU only.)
8-8
Command
Command
n : Transfer destination network No. (1 to 239) (BIN 16 bits)
: Head number of the devices where the data to be written is stored (Device name)
S
Internal Devices
R, ZR
Bit Word
––
or later in the area for the transfer destination network number
S
S Relay network number
+0
Relay station number
+1
+2 Dummy
or later ( +0 to +2) is 0, the data for the transfer destination network
S S S
or later exceeds each setting ranges.
S
exceeds the range of the corresponding device.
S
High
Basic
performance
S.RTWRITE
SP.RTWRITE
J \
U \G
Bit Word
––
––
or later.
S
(Individual data ranges)
(0 to 239)
(0 to 120)
Process
Redundant Universal LCPU
n
S
n
S
Constants
Zn Other
K, H
––
–– ––
.
S
(Error code: 4100)
(Error code: 4100)
(Error code: 4100)
(Error code: 4101)