Mitsubishi MELSEC Q Series Programming Manual page 953

Error
Error Contents and Cause
Code
[MISSING PARA.]
There is no parameter file in the drive specified as
valid parameter drive by the DIP switches.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
[MISSING PARA.]
There is no parameter file at the program memory.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
2200
[MISSING PARA.]
Parameter file does not exist in all drives where
parameters will be valid.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/STOP→RUN
[MISSING PARA.]
There is no parameter file in the program memory.
■Collateral information
• Common information: Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset/At writing to programmable
controller
[BOOT ERROR]
The contents of the boot file are incorrect.
■Collateral information
• Common information: Drive name
2210
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
[BOOT ERROR]
File formatting is failed at a boot.
■Collateral information
• Common information: Drive name
2211
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
[BOOT ERROR]
The file was booted from the SD memory card to
the program memory or standard ROM but it was
not booted to the CPU module due to either of the
following reasons.
• The passwords for the password 32 do not
match between transfer source file and
destination file.
2213
• The password 32 is not configured for the
transfer source file while it is configured for the
destination file.
■Collateral information
• Common information: File name/Drive name
• Individual information:-
■Diagnostic Timing
• At power-on/At reset
Corrective Action
• Check and correct the valid parameter drive
settings made by the DIP switches.
• Set the parameter file to the drive specified as
valid parameter drive by the DIP switches.
Set the parameter file to the program memory.
Set a parameter file in a drive to be valid.
Write parameter files to the program memory of
the CPU module.
Check the boot setting.
• Reboot.
• The cause is a hardware failure of the CPU
module. (Please consult your local Mitsubishi
representative, explaining a detailed
description of the problem.)
• Check the setting of the password 32 for the
transfer source file and destination files.
• Delete the boot setting from the parameter file
of the SD memory card.
LED Status Corresponding
CPU Status CPU
Qn(H)
QnPH
QnPRH
Q00J/Q00/Q01
QnU
LCPU
RUN:
off
ERR.:
Flicker
Q00J/Q00/Q01
CPU Status:
Qn(H)
Stop
QnPH
QnPRH
QnU
LCPU
Qn(H)
QnPRH
QnU
LCPU
LCPU
12-33
1
2
3
12
6
6
7
8
*8