Mitsubishi MELSEC Q Series Programming Manual page 337

6.5.2
Jump to END (GOEND)
GOEND
GOEND
Setting
Data
––
Function
(1) Jumps to the FEND or END instruction in the same program file.
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and
an error code is stored into SD0.
• The GOEND instruction has been executed after the execution of the CALL, ECALL
instruction, and prior to the execution of the RET instruction.
• The GOEND instruction has been executed after the execution of the FOR instruction,
and prior to the execution of the NEXT instruction.
• The GOEND instruction has been executed during an interrupt program but prior to the
execution of the IRET instruction.
• The GOEND instruction was executed between the CHKCIR and CHKEND instruction
block.
• The GOEND instruction was executed between the IX and IXEND instruction block.
Program Example
(1) The following program jumps to the END instruction if D0 holds a negative number.
[Ladder Mode]
Command
Internal Devices
R, ZR
Bit Word
High
Basic
performance
J \
U \G
Bit Word
––
[List Mode]
Instruction
Step
GOEND
Process
Redundant Universal LCPU
GOEND
Zn Constants Other
(Error code: 4211)
(Error code: 4200)
(Error code: 4221)
(Error code: 4230)
(Error code: 4231)
Device
6-135
1
2
3
4
4
6
7
8