Mitsubishi MELSEC Q Series Programming Manual page 702

ZONE(P),DZONE(P)
Program Example
(1) The following program performs zone control by applying negative and positive bias values
of 100 to 100 for the data set at D0 and stores the result of control at D1 when X0 is turned
ON.
[Ladder Mode]
[Operation]
• The value (D0) + ( 100) is stored at D1 if D0
Example
• The value 0 is stored at D1 if D0
• The value of (D0) + 100 is stored at D1 if 0
Example
(2) The following program performs zone control by applying negative and positive bias values
of 10000 to 10000 for the data set at D0 and D1 and stores the result of control at D10 and
D11 when X1 is turned ON.
[Ladder Mode]
[Operation]
• The value (D1, D0) + ( 10000) is stored at (D11, D10) if (D1, D0)
Example
• The value 0 is stored at (D11, D10) if (D1, D0)
• The value (D1, D0) + 10000 is stored at (D11, D10) if 0
Example
7-328
D0 200 D1 300
0.
D0 700 D1 800
(D1,D0) 12345 (D11,D10)
(D1,D0) 50000 (D11,D10) 60000
[List Mode]
Step Instruction
0.
D0.
[List Mode]
Step Instruction
0.
22345
0.
(D1, D0).
Device
Device