Voip Route Show Command - ZyXEL Communications MSC1000G User Manual

The following example creates a static route to send VoIP traffic on slot 4 to destination IP address
192.23.19.233 through a gateway at IP address 192.23.15.253.
ras> voip route set 4 192.23.19.233 192.23.15.253 5

36.12.3 voip route show Command

Syntax:
voip route show <slot>
This command displays the routing table for the specified slot. An example is shown next.
ras> voip route show 4
ip/mask
------------------ --------------- ------
192.23.15.0
192.23.19.233
192.168.1.0
36.13 voip sip dialplan
Use these commands to configure the SIP server to which a call goes.
36.13.1 voip sip dialplan delete Command
Syntax:
voip sip dialplan delete <name>
where
<name>
This command removes the specified dial plan table.
36.13.2 voip sip dialplan map Command
Syntax:
voip sip dialplan map [<name>]
Management Switch Card User's Guide
gateway metric
/24 192.23.15.86
/32 192.23.15.253
/24 192.168.1.2
=
The dial plan table name (<32 characters).
1
5
1
Chapter 36 voip Commands
1085