Rfdb (Option) - Ricoh D124-17 Service Manual

5. Check the pins and make sure that they are not bent. Straighten them gently with a small
screwdriver if they are bent.
6. Position the EEPROM on the socket of the new board so the semi-circular indentation [1] is pointing
up.
7. Make sure each pin is matched with a hole, and then press down to insert the EEPROM.

RFDB (Option)

The RFDB is the board provided with Roll Unit 2 (an option).
Preparation
• Separate the Main Unit from the Scanner Unit
Remove:
• Rear cover page 234
page 205
Boards, HDD
497