Print Job To Sd Card - Ricoh D124-17 Service Manual

5. System Maintenance Reference
• If this upload is done with the NVRAM folder and file from a previous upload is stored on the
SD card, the folder and file will be overwritten. (A new directory and file are not created.)
Downloading NVRAM Data from an SD Card
Before you begin, please note:
• Downloading NVRAM data from an SD card may fail if the SD card is defective or if there is poor
connection between the controller and the MCU.
• If downloading NVRAM data from an SD card fails, just repeat the procedure.
• If the second attempt to download from the SD card fails, then you must enter the SP and UP
settings manually from the SMC report your printed before uploading the NVRAM data to the SD
card.
1. Turn the machine off.
2. Insert the SD card that holds the NVRAM data in Slot 2.
• The machine number included in the filename of the file on the SD card must match the
number of the machine.
3. Turn the machine on.
4. Enter the SP mode and open SP5825.
5. Touch [EXECUTE]. The download executes.
6. When the prompt that tells you that the operation has completed and that the machine must be re-
booted, touch [Exit].
7. Exit the SP mode and remove the SD card.
8. Cycle the machine off/on.

Print Job to SD Card

Overview
The Card Save function prints jobs to an SD card with no print output.
• Card Save mode is toggled using printer Bit Switch #1 bit number 4.
• Card Save will remain enabled until the SD card becomes full, or until all file names have been
used.
• Captures are stored on the SD card in the folder /prt/cardsave.
• File names are assigned sequentially from PRT00000.prn to PRT99999.prn.
572