Ricoh D124-17 Service Manual page 565

Normally, every time an error occurs debug information is recorded in volatile memory but this
information is lost when the machine is switched off and on.
After the Save Debug Log feature is turned on, it provides two performs two functions:
• After an error occurs, the error information is saved directly to the HDD for later retrieval
• The error information can be copied from the HDD to an SD card.
When a user is experiencing problems with the machine, follow the procedure below to set up the
machine so the error information is saved automatically to the HDD.
Switching On and Setting Up Save Debug Log
The debug information cannot be saved the until the "Save Debug Log" function has been switched on
and a target has been selected.
1. Enter the SP mode.
2. Select SP5857 and then touch [1].
3. On the control panel keypad, press "1" then press
on.
• The default setting is "0" (OFF). This feature must be switched on in order for the debug
information to be saved.
4. Next, select the target destination where the debug information will be saved.
• Under "5857 Save Debug Log".
• Touch "2 Target".
• Enter "2" with the operation panel key to select the hard disk as the target destination, then
press .
System Maintenance Tasks
. This switches the Save Debug Log feature
563