Ricoh D124-17 Service Manual page 888

2. Appendix 2: Service Program Mode
Sets the IP address of the RCG (Remote Communication Gate) destination for call
processing at the remote service center.
3 RCG Port
Sets the RCG port number of the destination for processing calls to the @Remote service
center.
[0 to 65 535/443/1]
4 RCG URL Path
Sets the URL path of the destination for processing calls to the @Remote service center.
17 Numeric characters allowed (0 to 17)
NVRAM Data Upload
Touch [EXECUTE] to upload the UP and SP mode data (except for counters and the serial
5824
number) from NVRAM on the control board to an SD card.
Note: While using this SP mode, always keep the front cover open. This prevents a
software module accessing the NVRAM during the upload.
NVRAM Data Download
Touch [EXECUTE] to download data from an SD card to the NVRAM in the machine.
5825
After downloading is completed, remove the SD card and turn the machine power off
and on.
5828 Network Setting
50 1284 Compatibility (Centro)
Enables or disables 1284 Compatibility.
[0 or 1/1/1/step]
0: Disabled, 1: Enabled
52 ECP (Centro)
Enables or disables ECP Compatibility.
[0 or 1/1/1/step]
0: Disabled, 1: Enabled
Note: This SP is activated only when SP5-828-50 is set to "1".
184
CTL