2. The side with the blue dot is the side with the shiny, wavy patterns facing up.
3. To see these patterns, hold the edge of the glass up toward a light and move the edge from to side
to side.
CIS Unit
Follow these cautions when removing the CIS unit:
• To preserve the alignment of its components and to prevent other damage, always handle the CIS
unit carefully to protect it from sudden shock and vibration.
• To prevent finger prints and smudges, never touch the CIS lens cover with bare hands.
• Clean the CIS lens cover with lens paper only. Never use tissue paper or cloth that could leave lint
or other particles on the lenses.
• To preserve the alignment of its components, always disconnect and re-connect the CIS unit at the
SIB. Never disconnect the signal or power supply harnesses from the CIS unit.
• Always handle the CIS unit carefully when it is out of the machine. Protect it from shock and
vibration.
Preparation
• Raise the Scanner Unit
Remove:
• Scanner Rear Cover
• Scanner Left and Right Covers
• Exposure Glass
page 260
1. At the rear [A], open the clamps around the harness in front of the FFCs (
page 243
page 244
Scanner
x3).
263