Rewinding A Roll - Ricoh D124-17 Service Manual

2. Installation
18. Lower the paper exit guide plate.
19. When the message on the operation panel prompts you to select cutting or no cutting:
• Touch [Cut] to make a clean edge if the paper has been cut manually or is damp. Selecting
"Cut" is strongly recommended.
• Touch [Do Not Cut] if you do not want a fresh cut on the leading edge of the paper.
20. When the next message prompts you to confirm the paper type and thickness, select the correct
setting for the paper type and thickness of the paper loaded in the machine.
• Touch [Match] if the Paper Type and Paper Thickness Settings match those of the paper
loaded in the machine.
-or-
• Touch [Does Not Match] if the Paper Type and Paper Thickness Settings do not match those of
the paper loaded in the machine. Then input the correct settings.
21. The roll paper feeds into the machine.
• Next, the paper will feed out of the machine, reverse feed, and then automatically stop at the
prescribed print start position.
• If [Cut] was selected at Step 17, then the leading edge of the paper is cut off.
22. Check the display and make sure that correct setting for the paper size is selected.

Rewinding a Roll

You need to rewind the roll before removing it for temporary storage or swapping it for another roll.
128