Set Roll Paper - Ricoh D124-17 Service Manual

14. After the procedure is completed, open SP2012-001 and confirm that it displays "0".
15. Discard the filled primer fluid drain cartridges.
• Obey the local laws and regulations regarding the disposal of items such as the primer fluid
drain cartridges.
If Draining Fails to Start
If one or more of the ID chips on the drain cartridges is damaged, the operation may not start. Even if
you set SP2100-004 to "15", the fluid will fail to drain from the tubes, ink sub tanks, and print heads.
1. Open SP2012-001 and set it to "3".
2. Turn the machine off.
3. Remove the drain cartridges, and then replace them with the ink starter cartridges.
4. Close the ink cartridge cover.
5. Turn the machine on.
• Ink filling starts.
• The ink and primer fluid are purged from the tubes, ink sub tanks and the print heads into the
ink collector tank.
6. After the operation is completed, flush all the print heads three times. ([User Tools> Maintenance>
Flush Print Heads> Select all]).
• At the end of filling and purging of ink and fluid into the ink collector tank, SP2012-001 resets
automatically to "0"
7. Print a Nozzle Check Pattern to check the condition of the print heads.

Set Roll Paper

1. Select a paper type for each paper feed station: User Tool > System Settings > Tray Paper Setting >
Next > Paper Type: Tray n
2. Select the paper type for each paper feed station:
• Paper Type: Paper Bypass
• Paper Type: Paper Input 1
• Paper Type: Paper Input 2
3. Make sure that the machine is turned on.
Main Machine Installation
123