Ricoh D124-17 Service Manual page 102

2. Installation
7. Insert the cable into the controller, set the round clamp [B] around the cable and then attach the
clamp to the faceplate of the controller (
8. Make sure the USB cable is routed as shown.
9. Pull the cable [C] through the clamps to remove as much slack as possible.
Connect and Clamp the Power Cord, Clamp the Main Harness
1. Make sure that the power switch is OFF.
2. Confirm that the power cord is not connected to the power source.
3. Attach the medium-size clamps, connect the power cord [A], and then close the clamps (
4. Attach the large clamps, and then clamp the scanner I/F cable as shown above (
• Do not connect the power cable to the power source at this time.
100
x1 M3x8).
x3).
x3).