Cis Adjustment With Sp Modes - Ricoh D124-17 Service Manual

Cut Length (mm)

CIS Adjustment with SP Modes

To Print the CIS Adjustment Pattern
1. Open the roll unit drawer and cut off a sheet of paper from the widest roll. (Turn the manual feed
knob to feed the paper, then push the cutter from side to side to cut.)
2. Close the roll unit drawer.
3. Enter the SP mode.
4. Open SP4417 Pattern 8, and touch [OK].
5. Touch "COPY Window" to go to the main screen.
6. On the operation panel, select one of the rolls for paper feed.
7. Put the blank sheet of paper on the original feed tray and feed it into the original feed unit. Pattern
6 (a grid pattern) prints.
8. Touch "SP Mode" to return to the SP mode.
9. Open SP4973, push [0] on the operation panel to change the setting from "2" to "0", then push
[#].
10. Touch "Exit" twice to leave the SP mode.
11. Select the paper input size, and then copy the grid pattern that you printed in Step 7 above.
Cut Tolerance (mm)
to 3000
to 3600
to 15,000
±27.0
±33.0
±150
Special Adjustments
555