Ricoh D124-17 Service Manual page 840

2. Appendix 2: Service Program Mode
2 Position
Sets the original position where the motor speed adjustment for SP4965-1 starts.
[0 to 200/112/1 mm]
3 Trailing Edge
Specifies the point 14.5 mm past the original set sensor where the speed of the original
exit motor should be adjusted.
[-1 to 1/0.3/0.1%]
4966 Scan Speed Adjustment
This SP sets the speed of the scanner motor when it is tested with SP5804.
[5 to 170/80/0.1 mm/s]
4972 Scan Correction
These SP's correct the alignment the image scanned by the CIS.
1 CIS Joint Adjustment CIS1-2 Main Scan
[0 to 656/358/1]
2 CIS Joint Adjustment CIS2 Main Scan
[0 to 656/423/1]
3 CIS Joint Adjustment CIS2-3 Main Scan
[0 to 656/424/1]
4 CIS Joint Adjustment CIS3-4 Main Scan
[0 to 656/425/1]
5 CIS Joint Adjustment CIS4-5 Main Scan
[0 to 656/426/1]
6 CIS Joint Adjustment CIS1-2 Sub Scan
[0 to 2815/2480/1]
7 CIS Joint Adjustment CIS2 Sub Scan
136