Ricoh D124-17 Service Manual page 103

Dock the Scanner Stand to the Main Unit
1. Lower the four bolts on the base of the main unit stand.
• You may need a wrench to loosen the bolts until you can lower them by hand.
• Lower them until the tops are flat with the top of the stand feet but the bottoms do not touch the
floor.
• This prevents the bolts from interfering with the docking of the scanner stand and the
installation of the exit stacker.
2. At the rear, attach a joint bracket to each side of the stand (
3. Dock the left side of the scanner to the back of the main unit.
Main Machine Installation
x2 each).
101