Ricoh D124-17 Service Manual page 473

6. Close the front cover if it is up.
7. Make sure that the paper exit guide is down.
8. Set the service ink cartridges in the new ink supply unit.
9. The dummy tank [1] is provided with a nozzle plate [2].
10. Snap the nozzle plate onto the top of the dummy tank.
11. Set the dummy tank on the platen.
12. Connect each tube to the top of the box. The order of connection is not important.
13. Before going to the next step, check:
• FFCs on the carriage unit must be connected to prevent an error.
• Front cover must be down so that the cover sensor detects the front cover closed.
• Paper exit guide must be down so that the guide sensor detects that the guide down.
• Right covers must be attached so that the ink collector sensor detects that the cover is closed.
• Ink cartridge cover must be attached.
Ink Supply
471