Ricoh D124-17 Service Manual page 641

Delete all error 1 (DOS)
A data error was detected for the HDD/NVRAM after the "Delete All" option
was used.
Note: The source of this error is the Data Overwrite Security Unit running from an
SC874 D
SD card.
• Cycle the machine off/on.
• Confirm that DOS has been enabled with SP5878..
• HDD defective.
Delete al error 2: Data area
An error occurred while the machine deleted data from the HDD
SC875 D
Note: The source of this error is the Data Overwrite Security Unit running from an
SD card.
• Cycle the machine off/on
Log Data Error
An error was detected in the handling of the log data at power on or during
SC876 D
machine operation. This can be caused by switching the machine off while it is
operating.
Log Data Error 1
01 D • Damaged log data file in the HDD
• Initialize the HDD with SP5-832-004.
Log Data Error 2
• An encryption module not installed
02 D
• Replace or set again the encryption module.
• Disable the log encryption setting with SP9-730-004 ("0" is off.).
Log Data Error 3
• Invalid log encryption key due to defective NVRAM data
03 D
• Initialize the HDD with SP5-832-004.
• Disable the log encryption setting with SP9-730-004 ("0" is off.)
SC800: Firmware
CTL
CTL
CTL
639