Table of Contents
Advertisement
5.5 Output specification
Item
Signal name
Circuit isolation
Operation indication
External power
supply
Load current
Open circuit leak
current
Output ON voltage
Response time
Turning ON rate of
I/O simultaneously
This manual confers no industrial property rights or any rights of any other kind, nor does it
confer any patent licenses. Mitsubishi Electric Corporation cannot be held responsible for any
problems involving industrial property rights which may occur as a result of using the contents
noted in this manual.
Guidelines for the safety of the user and protection of the FX
POSITIONING CONTROLLER
•
This manual has been written to be used by trained and competent personnel. This is defined
by the European directives for machinery, low voltage and EMC.
•
If in doubt at any stage during the installation of the FX
electrical engineer who is qualified and trained to the local and national standards. If in doubt
about the operation or use of the FX
distributor.
•
Under no circumstances will Mitsubishi Electric be liable or responsible for any consequential
damage that may arise as a result of the installation or use of this equipment.
•
All examples and diagrams shown in this manual are intended only as an aid to understand-
ing the text, not to guarantee operation. Mitsubishi Electric will accept no responsibility for
actual use of the product based on these illustrative examples.
•
Owing to the very great variety in possible application of this equipment, you must satisfy
yourself as to its suitability for your specific application.
HEAD OFFICE : TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
HIMEJI WORKS : 840, CHIYODA CHO, HIMEJI, JAPAN
JY992D77601C
General-purpose output
Y00 to Y07
By photocoupler
LED is lit while output is ON
5 to 24V DC ± 10%
50mA or less
0.1mA/24V DC or less
0.5V max
0.2ms max. for both OFF → → → → ON and
ON → → → → OFF.
50% or less
2N
Manual number : JY992D77601
Manual revision : C
Date
FP , RP , CLR
By photocoupler
LED is lit while output is ON
5 to 24V DC ± 10%
20mA or less
0.1mA/24V DC or less
0.5V max (CLR is 1.5V max.)
Pulse output FP RP is 200kHz max.
Pulse output width of the CLR signal:
Approx. 20msec.
-20GM always consult a professional
2N
-20GM please consult the nearest Mitsubishi Electric
: November 2005
Specifications are subject to change without notice.
Output to drive unit
-20GM
2N
Effective Nov. 2005
Advertisement
Table of Contents
