Chrysler neon 1997 Service Manual page 1495

21 - 52 TRANSAXLE
DIAGNOSIS AND TESTING (Continued)
CONDITION
HARSH UPSHIFT
DELAYED UPSHIFT
NO TORQUE
CONVERTER CLUTCH
APPLICATION
POSSIBLE CAUSES
1. Hydraulic pressures too low.
2. Incorrect throttle linkage adjustment.
3. Kickdown band out of adjustment.
4. Hydraulic pressure too high.
5. Engine performance.
1. Incorrect throttle linkage adjustment.
2. Kickdown band out of adjustment.
3. Governor support seal rings worn.
4. Worn reaction shaft support seal rings.
5. Governor malfunction.
6. Kickdown band, servo or linkage
malfunction.
7. Worn front clutch.
8. Engine performance.
1. Stuck cooler flow switch valve.
2. Hydraulic pressures too low.
3. Low fluid level.
4. Faulty oil pump.
5. Worn input shaft seal rings.
6. Aerated fluid.
Diagnosis Guide
CORRECTION
1. Check fluid pressure at ports.
2. Adjust throttle linkage.
3. Adjust kickdown band.
4. Check fluid pressure at ports.
5. Set up engine to specs.
1. Adjust throttle linkage.
2. Adjust kickdown band.
3. Replace governor support seal
rings.
4. Replace reaction shaft support seal
rings.
5. Inspect and repair governor.
6. Inspect and repair kickdown band,
servo or linkage.
7. Replace discs and seals at front
clutch.
8. Set up engine to specs.
1. Replace switch valve behind oil
pump housing.
2. Check fluid pressure at ports.
3. Fill trans. to level.
4. Replace oil pump.
5. Replace input shaft seal rings.
6. Replace trans. fluid.
PL