Chrysler neon 1997 Service Manual page 1212

SPECIAL M12 — 1.75 WASHER BEARING SPECIAL TOOL 1026 TOOL FROM AND 150 MM BOLT, INSERT 6827–A TOOL 6792 SPECIAL THRUST
PL
REMOVAL AND INSTALLATION (Continued)
(3) Remove crankshaft
damper using the large side of Special Tool 1026 and
insert 6827–A (Fig. 87).
Fig. 87 Crankshaft Damper—Removal
INSTALLATION
(1) Install crankshaft damper using M12-1.75 x
150 mm bolt, washer, thrust bearing and nut from
Special Tool 6792. Install crankshaft damper bolt and
tighten to 142 N·m (105 ft. lbs.) (Fig. 88).
(2) Install accessory drive belts. Refer to Group 7,
Cooling System Accessory Drive section for proce-
dure.
(3) Raise vehicle on hoist and install right inner
splash shield.
Fig. 88 Crankshaft Damper—Installation
damper bolt. Remove DISASSEMBLY AND ASSEMBLY
OUTERROTOR INNER ROTOR RELIEF V ALVE RETAINER CAP SPRING
OIL PUMP
(1) To remove the relief valve, proceed as follows:
(2) Remove the threaded plug and gasket from the
oil pump (Fig. 89).
CAUTION: Oil pump pressure relief valve must be
installed as shown in (Fig. 89) or serious damage
may occur.
(3) Remove spring and relief valve (Fig. 89).
Fig. 89 Oil Pressure Relief Valve
(4) Remove oil pump cover screws, and lift off
cover.
(5) Remove pump rotors.
(6) Wash all parts in a suitable solvent and inspect
carefully for damage or wear (Fig. 90).
Fig. 90 Oil Pump
2.0L SOHC ENGINE
OIL PUMP COVER GASKET OIL PUMP BODY OIL
9 - 41
BODY PUMP