Chrysler neon 1997 Service Manual page 1611

WINDOW REGULATOR FRONT DOOR
23 - 26 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 23 Front Door Power Window Regulator
INSTALLATION
(1) Install power window motor on regulator, if so
equipped. Refer to Group 8S for Power Window
Motor procedures.
(2) Move window regulator into position in door
and engage bolt heads in key-slots in inner door
panel.
(3) Tighten bolts attaching regulator crank/motor
to door panel.
(4) Install nuts holding top and bottom of window
regulator to door panel.
(5) Install door glass. Refer to procedures in this
section to verify and adjust glass alignment.
(6) Connect wire connector to power window motor,
if so equipped.
(7) Install door speaker, if so equipped.
(8) Install door trim panel and water shield.
FRONT VERTICAL GUIDE BAR
REMOVAL
(1) Remove door trim panel and water shield.
(2) Remove door speaker, if equipped.
(3) Remove front lift guide.
(4) Remove bolt holding top of front guide bar to
inner door panel.
(5) Using a Snap-on
and a hex wrench, remove nut holding bottom of
guide bar to door panel while holding jack screws.
(Fig. 24)
(6) Remove front vertical guide bar through
speaker hole in inner door panel (Fig. 25).
INSTALLATION
Reverse the preceding operation. Verify door glass
alignment, adjust if necessary.
POWER WINDOW MOTOR
flare-nut socket (FRXM10)
FRONT SPEAKER HOLE GUIDE BAR VERTICAL
UP-STOP
ADJUSTER
Fig. 24 Front Vertical Guide Bar
Fig. 25 Front Guide
REAR VERTICAL GUIDE BAR
REMOVAL
(1) Remove door trim panel and water shield.
(2) Remove nut holding top of rear guide bar to
inner door panel.
(3) Using a Snap-on
and a hex wrench, remove nut holding bottom of
guide bar to door panel while holding jack screws.
(4) Remove rear vertical guide bar through large
access hole in inner door panel (Fig. 26).
INSTALLATION
Reverse the preceding operations and verify glass
alignment.
FRONT DOOR LATCH
REMOVAL
(1) Remove door trim panel and water shield.
(2) Close door glass.
FRONT DOOR FRONT DOOR NUT JACK SCREW FRONT LIFT
flare-nut socket (FRXM10)
GUIDE
PL