Chrysler neon 1997 Service Manual page 1476

GEAR CASE TOOL L-4518 SPECIAL SPECIAL TOOL L-4518
PL
DISASSEMBLY AND ASSEMBLY (Continued)
DIFFERENTIAL BEARING CUPS
REMOVAL
(1) Remove differential assembly from gear case
using the procedure outlined in this group.
(2) Install Miller tool #L-4518 into the differential
bearing cup (Fig. 131).
Fig. 131 Tool Installed in Bearing
(3) Install the tool cup over the tool (Fig. 132).
Fig. 132 Tool Cup Installed
(4) Tighten the tool until the race is removed from
the case.
INSTALLATION
(1) Position the bearing cup into the case.
(2) Install the bearing cup onto Miller tool
#L-4520.
(3) Using Miller tool #L-4520 and C-4171 driver,
install differential bearing cup into the transaxle
case.
WRENCH GEAR CASE SPECIAL TOOL 6786 INPUT BEARING
SHIFT RAIL BUSHINGS
REMOVAL
(1) Thread tool #6786 into shift rail bushing.
(2) Install slide hammer #3752 onto tool.
(3) Remove bushing using slide hammer and tool
assembly (Fig. 133).
Fig. 133 Shift Rail Bushing Removal
INSTALLATION
(1) Line up replacement bushing in bore.
(2) Using tool #MD998343, tap bushing into bore
until flush with the chamfer in the case.
SHIFT SHAFT SEALS
It is not necessary to remove the shift shafts from
the transaxle to service the shift shaft seals.
REMOVAL
(1) Using a pick tool, pry up on the shift shaft seal
and remove seal from bore.
INSTALLATION
(1) Position new shift shaft seal in bore.
(2) Install shift shaft seal into bore using an
appropriate size deep-well socket.
SHIFT SELECTOR SHAFT
REMOVAL
(1) Disassemble transaxle using the procedure out-
lined in this group.
(2) With the transaxle disassembled, remove the
selector shaft by pushing on the shaft from the out-
side. Pull shaft out from the inside.
INSTALLATION
(1) Reverse removal procedure to install selector
shaft.
SLIDE HAMMER SHIFTER RAIL C-3752 BUSHING
TRANSAXLE 21 - 33