Chrysler neon 1997 Service Manual page 1610

FRONT DOOR FRONT DOOR POWER WINDOW MOTOR FRONT DOOR
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 19 Roller Channel
Fig. 20 Manual Window Regulator
Fig. 21 Power Window Regulator
INSTALLATION
(1) Install power window motor on regulator, if so
equipped. Refer to group 8S for Power Window Motor
procedures.
WINDOW REGULATOR ROLLER CHANNEL WINDOW REGULA- TOR
(2) Move window regulator into position in door
and engage bolt heads into key-hole slots in inner
door panel and tighten bolts.
(3) Install roller channel to door panel.
(4) Install bolt at rear of roller channel. Make sure
that bolt is aligned to mark on inner door panel
made previously.
(5) Tighten front and rear bolts of roller channel.
(6) Install nuts holding regulator lift channel to
door glass.
(7) Adjust door glass as described in this section.
(8) Connect wire connector to power window motor,
if so equipped.
(9) Install door speaker, if so equipped.
(10) Install door trim panel and water shield.
WINDOW REGULATOR—4 DOOR
NOTE: Power and manual door glass regulators are
serviced using the same procedures. For power
window motor service procedures, refer to Group
8S, Power Windows.
REMOVAL
(1) Remove door trim panel and water shield.
(2) Remove door glass.
(3) Disconnect wire connector to power window
motor, if so equipped.
(4) Remove nuts holding top of regulator to inner
door panel.
(5) Remove nuts holding bottom of regulator to
door panel (Fig. 22) and (Fig. 23).
(6) Loosen bolts holding regulator crank/motor to
door panel.
(7) Disengage bolts from key hole slots in door panel.
(8) Remove window regulator from access hole in FRONT DOOR
door panel.
(9) Remove power window motor from regulator, if
so equipped. Refer to Group 8S for Power Window
Motor procedures.
Fig. 22 Front Door Manual Window Regulator
BODY 23 - 25
WINDOW REGULATOR JACK SCREW