Chrysler neon 1997 Service Manual page 1607

23 - 22 BODY
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Replace any damaged or missing push–in fas-
teners from around perimeter of door trim panel.
(2) Place trim panel near door.
(3) Engage wire connector into power door lock
switch, mirror switch, and power window switch, if
so equipped.
(4) Insert latch rod into handle and engage clip.
(5) Engage trim panel into retainer channel at top
of door and push down to seat.
(6) Locate door trim panel to inner door panel by
aligning locating pins on backside of trim panel to
mating holes in inner door panel.
(7) Engage push-in fasteners to hold trim to door
panel around perimeter of trim panel.
(8) Install screw behind inside latch release han-
dle.
(9) Install screw inside arm rest pull cup.
(10) With the window in the down position, orien-
tate the window regulator crank handle appropri-
ately. Install the right handle at the 10 o'clock
position and the left handle at the 2 o'clock position,
if so equipped.
FRONT DOOR WATER SHIELD
REMOVAL
(1) Remove door trim panel.
(2) Remove Door speaker, if equipped.
(3) Remove door trim pull cup mount bracket.
(4) Disengage clip holding lock linkage to lock but-
ton bell crank.
(5) Peel water shield away from adhesive around
perimeter of inner door panel (Fig. 10).
Fig. 10 Water Shield
INSTALLATION
(1) Insure that enough
securely retain the watershield. Replace as necessary.
WATER SHIELD FRONT DOOR
adhesive remains
(2) Place the watershield into position and press
securely to adhesive making sure to properly route
wiring and linkages.
(3) Engage clip holding lock linkage to lock button
bell-crank.
(4) Install door trim pull cup mount bracket.
(5) Install door speaker, if equipped.
(6) Install door trim panel.
LOCK BUTTON BELL-CRANK
REMOVAL
(1) Remove door trim panel.
(2) Disengage clip holding lock linkage to bell- BELL-CRANK
crank
(3) Rotate bell-crank until retaining ears align
with slots in door panel.
(4) Separate bell-crank from door (Fig. 11).
Fig. 11 Lock Button Bell-crank
INSTALLATION
Reverse the preceding operation.
FRONT DOOR INNER BELT WEATHERSTRIP
REMOVAL
(1) Remove door trim panel.
(2) Separate weatherstrip from door.
INSTALLATION
(1) Push down on weatherstrip to engage channel
to door panel.
(2) Install door trim panel.
WINDOW INNERBELT STABILIZER
REMOVAL
(1) Remove door trim panel.
to
(2) Remove nut holding inner belt stabilizer to
door panel.
LOCK LINKAGE LOCK BUTTON
PL
LATCH LINKAGE