Chrysler neon 1997 Service Manual page 1455

CASE HALF GEAR PRY TOOL
21 - 12 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 30 Case Bolts
(3) Place two screwdrivers into the slots provided
in the case halves near the dowels (Fig. 31). Separate
the case halves (Fig. 32).
Fig. 31 Transaxle Case Halves
Fig. 32 Separate Case Halves
PRY SLOT BELLHOUSING HALF CASE HALVES CASE BOLTS INPUT SHAFT
(4) Remove bellhousing half from gear case half
(Fig. 33).
(5) Remove output shaft roller bearing from output
shaft.
(6) Remove differential assembly (Fig. 34).
(7) Remove reverse idler shaft bolt (Fig. 35).
Remove reverse idler gear (Fig. 36).
(8) Remove two screws retaining reverse fork
bracket (Fig. 37). Remove reverse fork bracket and
reverse cam blockout assembly (Fig. 38).
(9) Using snap–ring pliers, remove selector shaft
spacer (Fig. 39).
(10) Pull the selector shaft shift pin out of the slot
in the blocker assembly. Turn selector shaft up and
out of the way (Fig. 40).
(11) Remove transaxle end cover (Fig. 41) (Fig. 42).
(12) Remove two snap rings retaining the output
shaft and the input shaft to the bearings (Fig. 43).
(13) Using bench fixture and shims provided (Mill-
er tools # 6785, 6785-1, and 6785-2), turn transaxle
over. Install transaxle onto bench fixture (Fig. 44).
OUTPUT BELLHOUSING SHAFT
Fig. 33 Bellhousing Case Half Removal
Fig. 34 Differential Assembly Removal
CASE HALF GEAR CASE HALF DIFFERENTIAL DIFFERENTIAL CASE
PL