Chrysler neon 1997 Service Manual page 1633

23 - 48 BODY
ADJUSTMENTS (Continued)
(3) Loosen three glass attachment bolts.
(4) Raise glass to top of travel and adjust glass to
fit the B-pillar seal. Glass to B-pillar applique gap
should be approximately 13mm (1/2 inch).
(5) Tighten the two accessible glass fasteners in
the full up position.
(6) Lower door glass to the full down position and
tighten the remaining glass fastener.
(7) Raise glass to top of travel and verify position-
ing. (Fig. 87)
FRONT DOOR LATCH ADJUSTMENT
(1) Insert a hex-wrench through the elongated hole
in the door end frame near the latch striker opening
(Fig. 88).
(2) Loosen socket head screw on the side of the
latch linkage.
(3) Lift upward on outside door handle and release
it.
(4) Tighten socket head screw on latch.
(5) Verify latch operation.
REAR DOOR GLASS ADJUSTMENT
UP-STOP ADJUSTMENTS
(1) Remove door trim panel.
(2) Remove water shield as necessary to gain
access to adjusters.
(3) Using a Snap-on
loosen up- stop eccentric jamb-nut (Fig. 89).
(4) Using a suitable hex-wrench, rotate up-stop
eccentric to achieve proper glass height.
Fig. 87 Front/Rear Glass Position
flare-nut socket (FRXM10),
LATCH ROD
Fig. 88 Door Latch Adjustment
(5) Adjust glass so that a piece of paper can be
pulled between the glass and weatherstrip with some
tension.
TOP OF GLASS—INBOARD/OUTBOARD
ADJUSTMENTS
(1) Remove door trim panel.
(2) Remove water shield as necessary to gain
access to adjusters.
HEX WRENCH LATCH
PL