Chrysler neon 1997 Service Manual page 1458

BENCH FIXTURE GEARTRAIN TRANSAXLE CASE
PL
DISASSEMBLY AND ASSEMBLY (Continued)
(16) Remove transaxle from press.
(17) Carefully remove transaxle case from the
shaft assemblies and bench fixture (Fig. 47). Be sure
the oil–feed trough to the end bearings is not dam-
aged (Fig. 48).
Fig. 47 Transaxle Case Removal
Fig. 48 Oil Feed Trough
(18) TRANSAXLE
Remove the reverse brake blocking ring, shim,
reverse brake friction cone, bearing and race from
the input shaft assembly (Fig. 49) (Fig. 50) (Fig. 51)
(Fig. 52) (Fig. 53). TRANSAXLE W/O REVERSE
BRAKE: Remove plastic spacer from the input shaft
assembly.
(19) Remove the shift blocker assembly from the
bench fixture (Fig. 54).
(20) Remove the 1-2 shift fork from the output
shaft (Fig. 55).
(21) Remove input and output shaft assemblies
from bench fixture (Fig. 56).
CAUTION: The output shaft assembly is serviced
as an assembly. Do not try to repair any component
OIL TROUGH FEED
W/REVERSE BRAKE:
BLOCKING BRAKE REVERSE RING
Fig. 49 Reverse Brake Shim
Fig. 50 Reverse Brake Friction Cone
Fig. 51 Reverse Brake Blocking Ring
on the output shaft. If the 1-2 synchronizer or gear
fails, it is necessary to replace the complete output
shaft assembly.
BRAKE SHIM REVERSE REVERSE FRICTION CONE FRICTION BRAKE REVERSE BRAKE CONE
TRANSAXLE 21 - 15