Chrysler neon 1997 Service Manual page 1362

POWER POWER FLUID GENERATOR STEERING STEERING PRESSURE STEERING GEAR SHIELD HOSE RESERVOIR FLUID ROUTING CLIP
PL
REMOVAL AND INSTALLATION (Continued)
(3) Disconnect power steering pressure hose (Fig.
9) at power steering gear. Drain power steering fluid
from power steering pump and hose through open
end of hose.
Fig. 9 Power Steering Pressure Hose At Steering
(4) Remove power steering pressure hose from
routing clip on generator shield (Fig. 10).
Fig. 10 Power Steering Pressure Hose Routing Clip
At Generator Shield
(5) Lower vehicle.
(6) Remove bolt, attaching power steering pressure
hose routing clip, to generator shield (Fig. 11).
(7) Loosen and remove Banjo bolt, and power
steering pressure hose from pressure fitting on power
steering pump (Fig. 12).
(8) Power steering fluid pressure hose is removed
from the vehicle from the top of the engine compart-
ment.
(9) Discard all used O-rings located at ends of
power steering pressure hose and Banjo bolt.
POWER PRESSURE SWITCH POWER BOLT RETURN HOSE STEERING POWER STEERING HOSE CLAMP POWER STEERING PRES- STEERING RETURN HOSE SURE HOSE TUBE CLIP FLUID
Gear
POWER STEERING FLUID ALTERNATOR ING POWER STEER- POWER STEER- BRACKET SHIELD ING PUMP PUMP RESERVOIR ROUTING CLIP
Fig. 11 Power Steering Hose Attachment To
Generator Shield
Fig. 12 Power Steering Hose Attachment To Power
Steering Pump
INSTALL
(1) Install power steering pressure hose in vehicle
from top of engine compartment.
(2) Using a lint free towel, wipe clean all open
power steering hose ends, and the power steering
pump and steering gear ports.
(3) Install new O-ring on end of power steering
pressure hose banjo fitting (Fig. 13).
(4) Install a new O-ring (Fig. 14) on power steering
pressure hose banjo fitting bolt.
(5) Lubricate both O-rings using fresh clean power
steering fluid.
(6) Install banjo bolt into the power steering pres-
sure hose banjo fitting (Fig. 14).
(7) Attach power steering pressure hose to outlet
fitting on power steering pump (Fig. 12). Do not
tighten or torque pressure fitting Banjo bolt at
this time.
LOCATING PIN BOLT POWER STEERING PRES- POWER STEERING PRES- SURE HOSE BANJO BOLT SURE HOSE
TUBE CLIP
STEERING 19 - 15