Chrysler neon 1997 Service Manual page 1469

DIFFERENTIAL BEARING CONE SPEEDOMETER SPECIAL RING HANDLE C-4171 SPECIAL C-4996 DRIVE GEAR POSITION) BOLTS GEAR TOOL (NOTE TOOL ARBOR PRESS RAM
21 - 26 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
RING GEAR
Fig. 100 Remove Differential Bearing Cone
Fig. 101 Install Differential Bearing Cone
Fig. 102 Remove or Install Ring Gear Bolts and
Ring Gear
RING GEAR ADAPTER SPECIAL BEARING CONE TIAL DIFFEREN- ASSEMBLY (USE 4 PIECES) SPECIAL SPECIAL TOOL C-293 DIFFERENTIAL BEARING C-293-45 ASSEMBLY TOOL L-4410 TOOL
CAUTION: Always install new ring gear bolts.
Tighten ring gear bolts to 81 N·m (60 ft. lbs.) torque.
SPEEDOMETER DRIVE GEAR
NOTE: The plastic speedometer drive gear must be
removed from the differential case in order to ser-
vice the differential gears
REMOVAL
the differential case using a flat blade pry tool (Fig.
103) (Fig. 104).
INSTALLATION
NOTE: A new speedometer drive gear must be
installed on differential assembly. The lip on the
speedometer drive gear must be positioned down-
ward when installing onto differential assembly.
DIFFERENTIAL SPEEDOMETER ASSEMBLY DRIVE GEAR
(1) Pry the plastic speedometer drive gear off of
Fig. 103 Pry Off Speedometer Drive Gear
Fig. 104 Speedometer Drive Gear Removed
SPEEDOMETER DIFFERENTIAL DRIVE GEAR ASSEMBLY
PL