Chrysler neon 1997 Service Manual page 1237

SIDESHIELD CRANKSHAFT DAMPER SCREW(3)
9 - 66 2.0L DOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
(3) Reverse removal procedure, for rest of installa-
tion.
VIBRATION DAMPER
NOTE: If a gap is found in the crankshaft damper,
in the area where the Poly-V Generator belt rides
this is normal and is acceptable (Fig. 85).
Fig. 34 Weld Gap
REMOVAL
(1) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure outlined in that sec-
tion.
(2) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 86).
Fig. 35 Right Inner Splash Shield
WELD GAP RIGHT FRAME SHIELD PLUG RAIL SPECIAL WASHER BEARING M12 — 1.75 SPECIAL TOOL 1026 TOOL FROM AND 150 MM BOLT, INSERT 6827–A TOOL 6792 SPECIAL THRUST
(3) Remove crankshaft
damper using the large side of Special Tool 1026 and
insert 6827–A (Fig. 87).
Fig. 36 Crankshaft Damper—Removal
INSTALLATION
(1) Install crankshaft damper using M12-1.75 x
150 mm bolt, washer, thrust bearing and nut from
Special Tool 6792. Install crankshaft damper bolt and
tighten to 142 N·m (105 ft. lbs.) (Fig. 88).
(2) Install accessory drive belts. Refer to Group 7,
Cooling System Accessory Drive section for proce-
dure.
(3) Raise vehicle on hoist and install right inner
splash shield.
Fig. 37 Crankshaft Damper—Installation
PL
damper bolt. Remove