Chrysler neon 1997 Service Manual page 1231

9 - 60 2.0L DOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 19 Positioning Engine Cradle Support Post
engine and left transmission mounts. Refer to proce-
dures outlined in this section.
(3) Remove safety straps from engine and trans-
mission assembly. Slowly raise vehicle enough to
remove the engine dolly and cradle.
(4) Install axle shafts. Refer to Group 2, Suspen-
sion and Driveshafts for procedure.
(5) Install transmission and engine braces and
splash shields.
(6) Connect exhaust system to manifold. Refer to
Group 11, Exhaust System and Intake Manifold for
procedure and torque specifications.
(7) Install power steering pump and reservoir.
Refer to Group 7, Cooling System Accessory Drive
Section for belt tension adjustment.
(8) Install A/C compressor and hoses. Refer to
Group 24, Heater and Air Conditioning for procedure.
(9) Install accessory drive belts. Refer to Group 7,
Cooling System Accessory Drive Section for belt ten-
sion adjustment.
(10) Install front engine mount. Refer to this sec-
tion for procedure.
(11) Manual transmission:
damper.
(12) Install inner splash shield. Install wheels and
tires.
(13) Manual Transmission: Connect clutch cable
and linkages. Refer to Group 6, Manual Transaxle
Clutch.
(14) Automatic Transmission: Connect shifter
and kickdown linkage. Refer to Group 21, Transaxle
for procedures.
Mounts
Install power
(15) Connect fuel line and heater hoses.
(16) Install ground straps. Connect engine and
throttle body connections and harnesses. Refer to
Group 8, Electrical for procedure.
(17) Connect throttle body linkage. Refer to Group
14, Fuel System for procedure.
(18) Install radiator and shroud assembly. Install
radiator hoses. Fill cooling system. Refer to Group 7,
Cooling System for filling procedure.
(19) Install battery tray and battery. Set Power-
train Control Module (PCM) into place.
(20) Install air cleaner and hoses.
(21) Install oil filter. Fill engine crankcase with
proper oil to correct level.
(22) Start engine and run until operating temper-
ature is reached.
(23) Adjust transmission linkage, if necessary.
ONE PIECE RUBBER GASKET
CYLINDER HEAD COVER
REMOVAL
(1) Remove ignition coil pack (Fig. 20).
Fig. 20 Ignition Coil Pack
(2) Remove the cylinder head cover fasteners (Fig.
21).
(3) Remove cylinder head cover from cylinder
head.
hop
Fig. 21 Cylinder Head Cover and Gasket
SPARK PLUG WELL GASKETS ELECTRICAL
IGNITION COIL FAS-
TENERS
PL
BAFFLE CONNECTOR